Shopping Cart

Product Quantity Price Subtotal
Cart Subtotal
Americas

Asia Pacific

Europe

Middle East and Africa

CT14: How to Install

Article ID :
000009562

The following procedure describes how to install the CT14.

Step 1: Install the Dial Pad Battery
Image of the CT14 dial pad battery installation process
  1. With the belt clip removed, squeeze the latch on the battery compartment cover and lift the cover.
  2. Connect the battery pack connector and place the battery pack into the battery compartment. NOTE: Do not force the plastic connectors; they only fit in one way.
  3. Insert tabs of the cover into the slots and push down to securely close the cover.
Step 2: Attach the Belt Clip
Image of the CT14 dial pad battery installation process
  1. Plug the headset cord into the 2.5mm jack on the top of the dial pad (a), and then route the cord through the dial pad's cable routing slot on the back of the dial pad (b).
  2. Insert the tabs on the sides of the belt clip into the holes on either side of the dial pad, and press down until it clicks into place.
Step 3: Set Up the Base
Image of the CT14 dial pad battery installation process
  1. Connect the AC power supply to the back of the base and a wall outlet. Be sure to route the power supply cable as shown.
  2. Raise the base antenna to a vertical position.

< Previous 10 | Next 10 >()

Filter by