MDA200: How to Set Up with an HL10 Lifter
Article ID :
How do I set up and use my MDA200 with the HL10 lifter?
To set up the MDA200 with the HL10 lifter:
Plug one end of the power supply into the power jack on the back of the MDA200 and the other end into a working power outlet.
- Firmly press the handset lifter power cord into the handset lifter jack.
- While wearing your headset, slide the handset lifter arm under the handset until the lifter base touches the side of the phone.
Slide the lifter up to where it nearly touches the handset earpiece.
Press the call control button on your headset to activate the lifter.
If you hear a dial tone the lifter is set correctly and needs no adjustment.
Remove the protective strips from the 3 mounting tapes on the underside of the lifter.
Gently place the lifter on the desk phone in the pre-determined position.
- Press firmly to adhere.
If You Do Not Hear a Dial Tone
- If you do not hear a dial tone, raise the lifter height switch to the next highest position.
Repeat steps 3 through 6 above as necessary until you hear a dial tone.
When you hear a dial tone, secure the lifter as described in steps 7 through 9.
Additional Parts (If Required)
Use the extender arm when the handset lifter needs additional stability lifting and returning the handset to the cradle.
Slide the extender arm onto the lifter.
The stabilizers can be shifted left and right. Position the stabilizers on the outsides of the handset to gently grip the phone.
Use the ringer microphone only when the telephone speaker is not located directly under the handset.
Remove the cover from the ringer microphone jack on the back of the lifter.
Connect the ringer from the microphone plug.
Place the ringer microphone over the phone speaker.