الانتقال إلى المحتوى

CA10/CS10: How to Change the Channel

معرف المقالة:
000009459

You should not have to adjust the channel settings on your CA10/CS10/CA10CD unless you experience cross talk (noise from one telephone that is audible on another), which can occur when the bases are too close together and on the same frequency.

To change the channel:
  1. Set both dials on the back of the base to 0 (zero). This causes the system to find the clearest channel on start up.
  2. Power cycle (turn off/turn on) the remote while it is in the charging base.