Преминете към съдържание

Voyager Pro UC (WG200/B and WG201/B): How to Pair

ИД за статия:
000001428

How do I pair my Voyager Pro UC with my cell phone (or other Bluetooth device) and adapter?

To pair your Voyager Pro UC with your phone or other device:
  1. On your cell phone, make sure Bluetooth is turned on.
  2. Start with the headset powered off. Press and hold the power button for about 5-6 seconds until the light on the headset starts flashing an alternating red-blue. Release the power button and set the headset aside.
  3. On your cell phone, go to the Bluetooth menu and search for (or add) a device. The cell phone should find the headset, which will appear as "ProPlantronics" in your list of devices.
  4. If prompted for a passkey, enter 0000 (four zeros). Note: Do not be alarmed if your phone does not prompt you for a passkey, because many phones do not.
To pair your Voyager Pro UC headset to its Bluetooth USB adapter:
Note: The Bluetooth USB adapter comes pre-paired to the headset; however, if you find that you need to pair your headset to the adapter again, you can do so by performing the following steps.
  1. Start with the headset powered off. Press and hold the power button for about 5-6 seconds until the light on the headset starts flashing an alternating red-blue. Release the power button and set the headset aside.
  2. With the Bluetooth USB adapter plugged into the computer, pinch the pairing button, until the light on the adapter starts flashing an alternating red-blue. Release the pairing button. The devices are paired once the light on the adapter turns solid blue and the light on the headset goes out.
Tip: For best performance, do not insert the USB adapter into a docking station.