Plantronics + Polycom. Сега заедно като лого

Кошница за пазаруване

Продукт Количество Цена Междинна сума
Междинна сума в количката

Discovery 925: Earpiece Controls

ИД за статия :
000006492
Turn On the Earpiece Press and hold the call control button for 2 seconds until the indicator glows blue.  If the earpiece flashes red 3 times when you turn on the earpiece then the battery is very low and should be recharged.
Note: When your earpiece is in standby mode, the indicator is off.  To confirm that your earpiece is on, press any button.  You should see a blue light flash. Turn Off the Earpiece Press and hold the call control button for 4 seconds until the indicator glows red.  When the power is off, the indicator stays off.
Note: If you're wearing the earpiece, you hear ascending tones when the power turns on and descending tones when the power turns off. Answer or Reject a Call When your earpiece rings, tap the power button once; you should hear 1 low tone.
To reject a call and send the caller to voice mail, press the call control button for 2 seconds.
Note: Your phone may ring before your earpiece rings.  Wait until you hear the ring in your earpiece to press the call control button and answer the call. End a Call During an active call, tap the call control button. Make a Call When the earpiece is paired to your phone and in range, enter the phone number on your phone and press send.  The call automatically transfers to your earpiece. Transfer a Call Between Earpiece and Phone During an active call, press and hold the call control button for 2 seconds.  You will hear a single low tone followed by a double low tone. Turning the Multipoint Feature On To prolong battery life, the multipoint feature is turned off by default.  For instructions on how to turn on the feature, click here. Turn Off the Online Indicator Press and hold the volume button for 4 seconds while the earpiece is on.  A blue light will dim over 2 seconds.  Repeat this action to activate online indicators.  The blue light will brighten over 2 seconds.  You will hear a single low tone, silence, and then a double low tone. Adjust the Volume During an active call, tap the volume button.
There are 3 volume settings.  Each tap will increase the volume until maximum volume is reached and you hear two low tones.  Tapping again will drop the volume to the minimum setting and subsequent taps will increase the volume until the maximum is again reached. Warning: Do not use headphones/earpieces at high volumes for an extended period of time.  Doing so can cause hearing loss.  Always listen at moderate levels.  See http://www.plantronics.com/healthandsafety for more information on earpieces and hearing.

No Results Found

Филтрирайте по